Modified Vehicle Cabin Air Spring W21-760-9000 Truck Spare Parts Replaced By VKNTECH 1S9000-1

Modified Vehicle air spring Cabin air spring W21-760-9000/ Air spring/ Truck spare parts replaced by VKNTECH 1S9000-1

Product Description

The VKNTECH 1S9000 air spring can serve as a replacement for the modified vehicle air spring and cabin air spring with the part number W21-760-9000. The VKNTECH 1S9000 air spring is designed to provide compatibility and can be used as a suitable alternative for the original air spring in modified vehicles or cabins.

Technical Drawing

Packaging & Delivery

Warning and Tips

Air suspension is a type of vehicle suspension powered by an electric or engine-driven air pump or compressor. This compressor pumps the air into a flexible bellows, usually made from textile-reinforced rubber. The air pressure inflates the bellows, and raises the chassis from the axle.

Air bag or air strut failure is usually caused by wet rust, due to old age, or moisture within the air system that damages it from the inside. Air ride suspension parts may fail because rubber dries out. Punctures to the air bag may be caused from debris on the road. With custom applications, improper installation may cause the air bags to rub against the vehicle's frame or other surrounding parts, damaging it. The over-extension of an air spring which is not sufficiently constrained by other suspension components, such as a shock absorber, may also lead to the premature failure of an air spring through the tearing of the flexible layers. Failure of an air spring may also result in complete immobilization of the vehicle, since the vehicle will rub against the ground or be too high to move. However, most modern automotive systems have overcome many of these problems.

Air fitting failure usually occurs when they are first fitted or very rarely in use. Cheap low quality components tend to be very unreliable. Air fittings are used to connect components such as bags, valves, and solenoids to the air line that transfers the air. They are screwed into the component and for the most part push-in or push-to-fit DOT line is then inserted into the fitting.

FAQ